Placeholder Image

Silicone Potting and Encapsulating Materials

Engineering Materials - Selection Guide
General Purpose - Potting and Encapsulating Materials

 

NuSil ID Cure System
Work Time
Mix Ratio
 Comments
CF-2616 - - - - 10:1 Two-part, optically clear, solvent free, low viscosity silicone
CF13-2186 Platinum 3 M 1:1 Low Viscosity, Fast Cure
CF15-2186 PT Addition 1:1 Short work time, very quick cure elastomer for potting, moulding and encapsulation. Suitab
CF16-2186 PT Addition 15 M 10:1 Medium Work Time Quick Cure Elastomer
CF18-2186 Platinum 25 M 1:1 Non-corrosive pourable silicone system
CF19-2186 PT Addition 15 M 1:1 Longer work time allowing more time to encapsulate, low durometer
CF19-2615 PT Addition 4 H 1:1 Low viscosity optically clear, solvent free
CF2-2186 PT Addition 2 HR 10:1 Medium Viscosity. All Purpose Plotting and Elastomer
CF20-2186 PT Addition 3 HR 1:1 1:1 Mix Ratio
CF3-2186 PT Addition 4 M 1:1 Two-part translucent pourable silicone system with low viscosity
R-2160 PT Addition 50 M 10:1 High temperature elastomer low viscosity
R-2186 PT Addition 2.5 H 10:1 All purpose silicone, encapsualnt or moulding, typical viscosity 80000 cps
R-2188 PT Addition 14 HR 1:1 Low Viscosity Low Modulus Elastomer
R-2615 PT Addition 4 HR 10:1 High durometer
R-2615-3 PT Addition 2 H 1:1 Low Viscosity RTV Elastomer, Red, Di-electric 500 vols/thou (20kv/mm)
R-2620 PT Addition 4.6 H 10:1 High Durometer Low Viscosity Elastomer
R-2652 PT Addition 10 M 10:1 Low durometer 65 type "00" Fast cure at 25 C
R-2655 PT Addition 10:1 260 C High and low temp elastomer. High refractive index 1.46
R28-2186 Platinum 1:1 Non-slump, potting and encapsulation. Rapid RTV cure.