 |
Back |
For full Warranty details please refer to the product profile!
50ml cart 1-1 kit
400ml cart 1-1 kit
2 pint kit 1 - 1 plastic
2 gallon kit 1 - 1 plastic bucket
10 gallon kit 1 - 1 plastic
Engineering Materials - General Purpose - Potting and Encapsulating Materials
Details: CF15-2186 - Short work time, very quick cure elastomer for potting, moulding and encapsulation. Suitab
| Product Profile: | CF15-2186P.pdf |
|---|---|
| MSDS PDF A: | CF152186A.pdf |
| MSDS PDF B: | CF152186B.pdf |
| MSDS PDF C: | |
Basic Product Overview: |
|
| Section: | Engineering Materials - General Purpose |
| Description: | Potting and Encapsulating Materials |
| NuSil ID: | CF15-2186 |
| Viscosity A: | |
| Viscosity B: | |
| Viscosity Mixed: | |
| Flow/Viscosity: | 75k |
| Cure System: | PT Addition |
| Solids Content: | |
| Work Time: | |
| Cure Time/Temp: | 1 D / R.T. |
| Post Cure Time/Temp: | |
| Specific Gravity: | 1.1 |
| Durometer Type A Certified: | |
| Durometer Type A Typical: | 30 |
| Tensile psi Certified: | |
| Tensile psi Typical: | 900 |
| Tensile MPa Certified: | |
| Tensile MPa Typical: | 6.2 |
| Elongation Percent Certified: | |
| Elongation Percent Typical: | 650 |
| Tear PPI Certified: | |
| Tear PPI Typical: | 90 |
| Tear kN/m Certified: | |
| Tear kN/m Typical: | 15.9 |
| Ionic Content* CI - K / Na ppm | |
| Lap Shear psi/Mpa: | 330/2.3 |
| Volume Resistivity** ohm·cm | |
| Dielectric Strength V/mil: | 730 |
| Operating Temp: | -65 to 240 |
| Plasticity/Viscosity/Extrusion Typical: | |
| Stress Strain: | |
| Mix Ratio: | 1:1 |
| Colour: | Trans |
| Comments: | Short work time, very quick cure elastomer for potting, moulding and encapsulation. Suitab |
|
Back | Please note: Alternative sizes and packaging can and may be supplied, subject to availability of stock. Products pictured may vary and illustrations are for guidance only! |
|
