 |
Back |
For full Warranty details please refer to the product profile!
Engineering Materials - General Purpose - Inks and Master Batches
Details: R-1008-6 - Green Coating / Marking one-part ink, flowable silicone elastomer dispersion
| Product Profile: | R-1008P.pdf |
|---|---|
| MSDS PDF A: | |
| MSDS PDF B: | |
| MSDS PDF C: | |
Basic Product Overview: |
|
| Section: | Engineering Materials - General Purpose |
| Description: | Inks and Master Batches |
| NuSil ID: | R-1008-6 |
| Viscosity A: | |
| Viscosity B: | |
| Viscosity Mixed: | |
| Flow/Viscosity: | - - |
| Cure System: | - - |
| Solids Content: | 60 |
| Work Time: | - - |
| Cure Time/Temp: | 7d @ 25°C 50% R |
| Post Cure Time/Temp: | - - |
| Specific Gravity: | - - |
| Durometer Type A Certified: | - - |
| Durometer Type A Typical: | - - |
| Tensile psi Certified: | - - |
| Tensile psi Typical: | 300 |
| Tensile MPa Certified: | - - |
| Tensile MPa Typical: | 2.07 |
| Elongation Percent Certified: | - - |
| Elongation Percent Typical: | 200 |
| Tear PPI Certified: | - - |
| Tear PPI Typical: | - - |
| Tear kN/m Certified: | - - |
| Tear kN/m Typical: | - - |
| Ionic Content* CI - K / Na ppm | |
| Lap Shear psi/Mpa: | - - |
| Volume Resistivity** ohm·cm | |
| Dielectric Strength V/mil: | - - |
| Operating Temp: | -65°C - 260° |
| Plasticity/Viscosity/Extrusion Typical: | - - |
| Stress Strain: | - - |
| Mix Ratio: | 1 Part |
| Colour: | Green |
| Comments: | Green Coating / Marking one-part ink, flowable silicone elastomer dispersion |
|
Back | Please note: Alternative sizes and packaging can and may be supplied, subject to availability of stock. Products pictured may vary and illustrations are for guidance only! |
|
