We use cookies to give you the best possible experience on our website. By continuing to browse this site, you give consent for cookies to be used. For more details please read our Privacy Policy
Back Back

 


For full Warranty details please refer to the product profile!

 

 

Engineering Materials - General Purpose - LSR Elastomers


Details: FS-3511 - Excellent for molding at rapid rates

Product Profile: FS-3511P.pdf
MSDS PDF A: FS3511A.pdf
MSDS PDF B: FS3511B.pdf
Basic Product Overview:
Section: Engineering Materials - General Purpose
Description: LSR Elastomers
NuSil ID: FS-3511
Viscosity A:
Viscosity B:
Viscosity Mixed:
Flow/Viscosity:
Cure System: Platinum Cure
Solids Content:
Work Time: 24 HR
Cure Time/Temp: 30 M / 150
Post Cure Time/Temp:
Specific Gravity: 1.39
Durometer Type A Certified:
Durometer Type A Typical: 42
Tensile psi Certified:
Tensile psi Typical: 850
Tensile MPa Certified:
Tensile MPa Typical: 5.9
Elongation Percent Certified:
Elongation Percent Typical: 240
Tear PPI Certified:
Tear PPI Typical: 40
Tear kN/m Certified:
Tear kN/m Typical: 7.1
Ionic Content* CI - K / Na ppm
Lap Shear psi/Mpa:
Volume Resistivity** ohm·cm
Dielectric Strength V/mil:
Operating Temp:
Plasticity/Viscosity/Extrusion Typical:
Stress Strain:
Mix Ratio: 1:1
Colour: Trans
Comments: Excellent for molding at rapid rates

 

Back
Back Please note:
Alternative sizes and packaging can and may be supplied, subject to availability of stock.
Products pictured may vary and illustrations are for guidance only!
 
       
       


#Cookies set! #Google set! #Piwik set!