 |
Back |
For full Warranty details please refer to the product profile!
Engineering Materials - General Purpose - Potting and Encapsulating Gels
Details: GEL-8250 - Low / High temperature Penetration 0.5mm
| Product Profile: | GEL-8250P.pdf |
|---|---|
| MSDS PDF A: | GEL8250AM.pdf |
| MSDS PDF B: | GEL8250BM.pdf |
| MSDS PDF C: | |
Basic Product Overview: |
|
| Section: | Engineering Materials - General Purpose |
| Description: | Potting and Encapsulating Gels |
| NuSil ID: | GEL-8250 |
| Viscosity A: | |
| Viscosity B: | |
| Viscosity Mixed: | |
| Flow/Viscosity: | 500 |
| Cure System: | PT Addition |
| Solids Content: | |
| Work Time: | 2 HR |
| Cure Time/Temp: | 30 M / 150 |
| Post Cure Time/Temp: | |
| Specific Gravity: | 0.98 |
| Durometer Type A Certified: | |
| Durometer Type A Typical: | |
| Tensile psi Certified: | |
| Tensile psi Typical: | |
| Tensile MPa Certified: | |
| Tensile MPa Typical: | |
| Elongation Percent Certified: | |
| Elongation Percent Typical: | |
| Tear PPI Certified: | |
| Tear PPI Typical: | |
| Tear kN/m Certified: | |
| Tear kN/m Typical: | |
| Ionic Content* CI - K / Na ppm | |
| Lap Shear psi/Mpa: | |
| Volume Resistivity** ohm·cm | |
| Dielectric Strength V/mil: | |
| Operating Temp: | -115 to 260 |
| Plasticity/Viscosity/Extrusion Typical: | |
| Stress Strain: | |
| Mix Ratio: | 1:1 |
| Colour: | Clear |
| Comments: | Low / High temperature Penetration 0.5mm |
|
Back | Please note: Alternative sizes and packaging can and may be supplied, subject to availability of stock. Products pictured may vary and illustrations are for guidance only! |
|
